O O P P E E R R A A T T I I N N G G T T H H E E A A P P P P L L I I A A N N C C E - VINCENT SV-234 Instructions For Use Manual

O O p p e e r r a a t t i i o o n n
Switch on and off
Individually activate or
deactivate speaker
outputs A and B
Select an input
Change the volume
Mute the speakers and
the preamplifier output
Vincent
3 3 8 8
O O P P E E R R A A T T I I N N G G T T H H E E A A P P P P L L I I A A N N C C E E
B B u u t t t t o o n n ( ( s s ) ) D D e e s s c c r r i i p p t t i i o o n n
The amplifier is switched on and off using this button at the front panel.
When switched off the device is not internally separated from the AC
power and reacts to a signal at the input "POWER CONTROL INPUT"
(15). That is why it is not possible to switch off the amplifier as long as
P P O O W W E E R R ( ( 5 5 ) ) a 12V trigger signal is present at this input.
WELCOME
As a precaution, after switching on, the volume setting should
be reduced.
To play back stero music via loudspeakers at least one pair of them
must be attached to the amplifier (a practical choice would be
S S P P E E A A K K E E R R
connectors "A"). The output you use must be activated using the
A A / / B B ( ( 1 1 ) ) corresponding button "SPEAKER" (LED illuminated). Only if a second
pair of speakers is used, it is necessary to activate the second speaker
output "B".
A short touch on the button for the desired input channel
("LINE1"..."LINE5" or "BALANCED") changes to the playback of the
audio source connected there. The front panel as well as the remote
I I n n p p u u t t S S e e l l e e c c t t o o r r control carry those buttons. The name of the currently selected input
b b u u t t t t o o n n s s channel appears in the display.
( ( 1 1 0 0 ) ) ( ( 1 1 1 1 ) ) ( ( 1 1 2 2 ) )
LINE2
Before switching over the input channel, the volume should be turned
down as a precaution!
Hold down the button "LEVEL " to turn the volume up. Use "LEVEL " to
turn it down. This can be done on the remote control as well as at the
amplifier front panel. The display (2) shows the momentarily selected
volume value. The minimum volume value is -99dB, the maximum volume
L L E E V V E E L L / /
appears at latest with 00dB, for most speakers much below this value.
( ( 3 3 ) ) ( ( 1 1 9 9 ) )
LINE2 -99dB
The volume value can not be changed if the input "LINE5 MAIN IN"
has been selected. In this case the display shows "MAX". The volume
setting dors never influence the signal at the output "REC OUTPUT" (13).
The MUTE function can only be operated with the remote control.
It switches off the loudspeakers, the preamplifier output "PRE OUTPUT"
(14) and the recording output "REC OUTPUT" (13). Pressing it again
M M U U T T E E ( ( 1 1 7 7 ) )
restores the volume to its original setting. As long as the amplifier is
muted, the display shows "MUTING".
MUTING
→
LINE2 -45dB
← ... → LINE2 00dB
← ... → MUTE OFF