Installing Rconsole (Netware) - HP NetServer E 60 Administrator's Manual

4 Installing RCONSOLE (NetWare)

Novell NetWare's RCONSOLE feature works at the NOS level to provide full remote access to a NetServer
running NetWare/intraNetWare. Installation of RCONSOLE requires specific setup steps at both the
console and NetServer before you can establish an RCONSOLE communications link. Only the NetServer
needs to be running NetWare/intraNetWare; the RCONSOLE program can be run from a DOS prompt.
Thus, the only software requirement is that the client has access to DOS.
The following figure shows how RCONSOLE works on a NetServer running NetWare.
At the Server
Enable the server for
NetWare
RCONSOLE
connection.
Minimum Server Requirements
In order to use RCONSOLE, your server needs:
•
An external modem or direct connection via one of the HP NetServer's two serial ports
•
An HP NetServer E Series system running Novell NetWare/intraNetWare (3.12 or 4.11),
intraNetWare for Small Business 1.10, and including RCONSOLE software and utilities
Minimum Console Requirements
For best results, use an ANSI color terminal that supports 25-line mode and IBM PC character set. In
addition, you will need:
•
A 386-based (or faster) computer with 6 MB of available disk space
•
A communications link to the server, either through a modem or a direct serial connection
•
Novell NetWare's RCONSOLE program
•
MSDOS 3.0 or later
Setup at the NetWare NetServer
Enabling a NetWare RCONSOLE connection at your NetServer involves several steps, including modifying
the AUTOEXEC. NCF file and rebooting the server in order to activate the changes.
To enable a NetWare RCONSOLE connection:
1. Run the NetWare server program and at the server prompt, type:
Modem
NetServer
Figure 4-1. RCONSOLE Remotely Controlling an HP NetServer
Remote
Console
Modem
At the Remote Console
Using a modem, the
offsite remote console
workstation, using
RCONSOLE, may dial
into and take control of
the HP NetServer.
21