Advertisement
Tool Specifications
Angle Grinder
Part number
Rated power*
Output power*
Idling speed
Grinding disk dia.
Grinder spindle threads
Weight (without
optional extras) approx.
Safety class
* The values given are valid for nominal voltages [U] of
230/240 V. However, these calues can vary for lower
voltages and models made for specific countries.
Operating Controls
1 On/Off switch
2 Auxiliary handle*
3 Spindle locking button
4 Grinding spindle
5 Protective hood
6 Screw
7 Retainer mounting flange M 10
8 Roughing/cutting disc*
9 Clamping nut
10 Hand protector*
11 Rubber sanding plate*
12 Sanding sheet*
13 Round nut*
14 Cup brush*
15 Diamond cutting disc*
16 Cutting guide with protective vacuuming
hood*
* Optional Extras
* Not all the illustrated or described accessories are
included as standard delivery.
Noise/Vibration Information
Measured values determined according to
EN 50 144.
The A-weighted noise levels of the tool are typi-
cally: Sound pressure level: 89 dB (A); sound
power level: 102 dB (A).
Wear ear protection!
The weighted acceleration is typically 5.0 m/s
6 • 2 609 140 111 • TMS • 08.05.01
GWS 6-100
0 601 375 0..
670 W
340 W
11 000 rpm
max. 100 mm
M 10
1.40 kg
/ II
2
.
English - 1
Intended Use
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is required.
Information about Statics
Slots in load-carrying walls are subject to Part 1
of
the
German
No. 1053, or to country-specific regulations.
These regulations are to be observed under all
circumstances. Before beginning work, consult
the responsible structural engineer, architects or
the construction supervisor.
For Your Safety
Working safely with this machine
is possible only when the operat-
ing and safety information is read
completely and the instructions
contained therein are strictly fol-
lowed. In addition, the general
safety instructions in the en-
closed booklet must be followed.
Before using for the first time,
ask for a practical demonstration.
If the cable is damaged or cut
through while working, do not touch
the cable and pull the plug immedi-
ately. Never use the machine with a
damaged cable.
Wear protective glasses and ear
protection.
The dust that is produced while
working can be detrimental to health,
inflammable or explosive. Suitable
safety measures are required.
Examples: Some dusts are re-
garded as carcinogenic. Use suit-
able dust-/chip extraction and wear
a dust mask.
Dust from light alloys can burn or explode.
Always keep the work place clean, as blends of
materials are particularly dangerous.
Wear protective gloves and sturdy
shoes.
When necessary, also ware an
apron.
Industrial
Standard (DIN)
Advertisement
