New Holland LS160 Manual page 465

REASSEMBLY
1. Clean all surfaces of old silicone sealer, dirt, etc.
that will require resealing.
2. If the oil requires replacement, the oil will have to
be syphoned from the case. Thoroughly clean
the inside of the case to remove all debris.
3. Install the front drive sprocket with the longer
center hub, 1, to the outside of the case.
NOTE: The drive sprockets are not centered on the
splined hub. The front sprocket is installed with the
longer center hub, 1, to the outside and rear is
installed with the longer center hub to the inside of
case.
4. Install the front drive chain, 1.
NOTE: The front drive chain is longer than the rear
drive chain.
5. Place the chain over the inside drive sprocket, 2.
6. Install the rear drive sprocket, with the long cen-
ter hub to the inside of the case, and the short hub
to the outside as shown at 1.
7. Install the rear drive chain, the shorter chain, over
the sprocket and slide the chain and sprocket to
the rear.
8. Place the drive chain over the outside drive
sprocket.
NOTE: If the hydrostatic motor and coupler was
moved to gain clearance, the motor will require re-
positioning.
SECTION 44 - AXLES AND WHEELS
44-20
42
43
44