When Such A Display Shows - Panasonic SR-AL108-W Operating Instructions Manual

When such a display shows

When such a display shows
Please check before requesting a repair.
Error display
If the warm jar is still not back to normal after the above is confirmed, go to the Panasonic authorized
service center for repair.
●
Has the pan being set?
→Press the [Off/Cancel] key until the error display disappears. Put the
dedicated pan in, and perform the operation again.
●
Is any foreign object attached to the bottom of the pan or the bottom sensor?
→Please remove foreign objects and dirt, and then press the [Off/Cancel] key.
●
Is water too much?
→Press the [Off/Cancel] key.
(For continuous cooking, you can slightly reduce the amount of water)
●
Keep warm duration over 96 hours?
→Please press [Off/Cancel] key.
●
Has any dust or other foreign object clogged the intake port and the exhaust
port at the bottom of the warm jar?
→Remove dust according to the following steps.
①Press the [Off/Cancel] key, and then unplug the power plug.
②Remove the pan until the warm jar cools down.
③Clear the dust in the intake port/exhaust port at the bottom of the warm jar.
( P11)
●
Is the warm jar used on the carpet?
→Do not use the warm jar where the bottom of the warm jar may be clogged.
●
Try to unplug the power plug and plug it in again.
If "H※※" still appears, then there is a fault.
→Please consult the Panasonic authorized service center, and inform the
error code (two digits after "H").
Please check
Ref.
page
—
4
7
8
—
4
—
15