Advertisement
Step 3 - Configure the Antenna
Follow the steps below to configure the antenna
to use the new PCB module. This procedure
requires a PC with the latest version of the Flash
Update Wizard installed.
NOTE: If you do not have the KVH Flash Update
Wizard installed, you can use Windows
HyperTerminal instead. Be sure to establish the
following settings: bits per second: 9600, data bits: 8,
parity: none, stop bits: 1, flow control: none.
a. Connect one end of a PC data cable to the
maintenance port on the rear of the MCU (see
Figure 5). Connect the other end to your PC.
NOTE: If your computer does not have a DB9
connector, you can use the following USB-to-RS232
adapters: Belkin part # F5U409 or # F5U109, or
IOGear part # GUC232A.
b. Apply power to the TracVision system.
c. Open the KVH Flash Update Wizard. You
will type the following commands into the
Flash Update Wizard's "command" box.
d. Type HALT then press Enter.
e. Type DEBUGON then press Enter
f. Type =TVM9 then press Enter.
g. Type ZAP then press Enter to restart the
system.
h. Wait two minutes for system startup.
i.
Type HALT then press Enter.
j.
Type DEBUGON then press Enter.
k. Type EL,300 then press Enter.
4
Figure 5 MCU Maintenance Port
®
Maintenance
Port
Advertisement
