Advertisement
Step 1 - Remove the Radome
Follow the steps below to remove the radome.
CAUTION
For your own safety, be sure to disconnect
power from all wired components before
performing this procedure.
a. Disconnect power from the TracVision
system and any connected receivers and/or
multiswitch.
b. Remove the eight Phillips screws securing the
radome (see Figure 1). Then remove the
radome and set it aside in a safe place.
Step 2 - Replace the PCB Module
Follow the instructions below to replace the PCB
module.
a. Using cutting pliers, cut and remove the tie-
wrap securing the cables to the back of the
PCB module (see Figure 2).
2
Figure 1 Radome Screws
Figure 2 Tie-wrap on PCB Module
Radome
#10-32 Screw (x8)
Baseplate
Tie-wrap
Advertisement
