Husqvarna DS 700 Operator's Manual page 14

• If the anchor method is used to secure the machine,
locate the anchor at the proper distance from the hole
to be drilled (cored).
WARNING!
Machine must be held securely to prevent injury
to operator or damage to machine!
Always anchor machine properly before drilling!
Anchors shall only be used if the material being
drilled has the mechanical strength required to
hold the anchor. Use the proper Anchor for the
material.
DO NOT use vacuum system to secure machine
to a wall (horizontal drilling) or a ceiling!
Use ONLY anchor bolts to secure the machine to
a wall or ceiling!
• As a minimum, use a 5/8" or M16 expansion-type
anchor (not supplied) that will accept a 5/8" or M16
threaded rod or bolt to secure the machine base to
the work surface.
• Install concrete anchor per the manufactures instruc-
tions and verify that it is securely held in place. For
more information on concrete anchors, contact the
Concrete Anchor Manufacturers' Association at www.
concreteanchors.org.
• Secure the drill stand base to the surface using a
5/8" or M16 Capscrew and Washer (U) (hardware
per anchor manufactures instructions) through the
Anchor Bolt Mounting Slot (V). Securely tighten the
mounting hardware (U) per the anchor manufactures
instructions.
Angle Drilling:
• This drill stand, as supplied, will only drill (core) holes
90 degrees to the mounting surface. Accessory items
can be fitted to the machine to allow drilling at an angle
to the mounting surface.
Angle Bracket Assembly
(DS 700 & DS 800)
The addition of this accessory will allow the drill stand
to tilt backwards (toward wheels) at up to a 45 degree
angle. Use the DS 700 / DS 800 spare parts list to de-
termine the correct part number for this accessory.
Angle Bracket (Column to Base)
(DS 800 Only)
The addition of this accessory will allow the DS 800
drill stand (not available for DS 700) to tilt backwards
(toward wheels) to approximately a 90 degree angle
from the mounting surface. Use the DS 700 / DS 800
spare parts list to determine the correct part number for
this accessory.

MACHINE SET-UP
Secure Drill Stand to Concrete Anchor with Anchor
Angle Bracket Assembly (T) (DS 700 / DS 800)
U
V
Bolt (U) Through Anchor Bolt Slot (V).
45
S
Angle Bracket Accessory (S) (DS 800)
A
(A2)
J
A
(A1 / A2)