Advertisement
Application Diagram
The following is a typical application diagram for the USB-C HD 101.
Figure 3.
USB-C HD 101 Application Diagram
LockIt Lacing Bracket
Use the LockIt Lacing Bracket to securely fasten both the USB-C and HDMI cables to the device as follows:
Plug the cable into the designated rear panel port.
1
Loosen the connection mounting screw from the panel, enough to allow the LockIt lacing bracket to be placed over
2
it. The screw does not need to be removed.
Place the LockIt lacing bracket on the screw and against the connector.
3
Then, tighten the screw to secure the bracket.
ATTENTION:
•
Do not overtighten the connector mounting screw. The shield it fastens
to is very thin and can easily be stripped.
•
Ne serrez pas trop la vis de montage du connecteur. Le blindage
auquel elle est attachée est très fin et peut facilement être dénudé.
4
Loosely place the included tie wrap around the connector and the LockIt lacing
bracket as shown.
5
While holding he connector securely against the lacing bracket, use pliers or
similar tool to tighten the tie wrap. Then, remove any excess length.
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide
©
2020 Extron Electronics — All rights reserved.
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
2
on the Extron website.
www.extron.com
3
3 3
1
1 1
3
4
4 4
5
5 5
Figure 4.
Lockit Bracket Installation
68-3562-50 Rev. A
2
2 2
07 20
Advertisement
