Oki ColorPainter M-64S User Manual page 75

<TUR unit errors>
CHCK TUR UNIT STATUS
PRINT? OK/CANCEL
<External dryer system errors>
(When printing or preheating starts)
CHECK EXTERNAL DRYER
SYSTEM CONNECTION
(During printing)
CHECK EXTERNAL DRYER
SYSTEM CONNECTION
<Extra ionizers errors>
CHECK EXTRA IONIZERS
CONNECTION TO BOARD
CHECK RIGHT EXTRA
IONIZER CONNECTION
CHECK LEFT EXTRA
IONIZER CONNECTION
Meaning
The TUR unit is not installed correctly.
Action
Check the following on the TUR unit and install it correctly.
Check that the take-up direction switch is set to the outer take-up
direction.
Check that the TUR unit is completely pushed inside the printer.
Meaning When printing or preheating started, the external dryer system turned
on but did not start warming up even after waiting for a while.
Action Check the following.
- The external dryer system is correctly connected to the printer.
- The external dryer system power supply is turned on.
* If you could not solve the problem after checking the above, contact
your dealer or a service representative.
Meaning An external dryer system error was detected during printing.
Action Check the following.
- The external dryer system is correctly connected to the printer.
- The external dryer system power supply is turned on.
* If you could not solve the problem after checking the above, contact
your dealer or a service representative.
Meaning The extra ionizer connector to the board is not connected properly.
Action Press any key to clear the error.
If this error occurs, contact your service representative.
However, if you want to continue printing without using the extra
ionizers, change the ionizer setting of the media preset for the currently
used media to OFF or ON.
Meaning
The connector of the extra ionizer on the carriage right side is not
connected properly.
Meaning
The connector of the extra ionizer on the carriage left side is not
connected properly.
75
Troubleshooting