Detecto Solace ID-3636S-855RMP Manual page 7

This is the Zero key. Press and release this key to reset the display to zero, up
to 100% of the indicator capacity.
This is the Lock/Release key. Press and release this key, or touch the weight
readout on the display to cause the weight, height, and BMI to lock on the
current values until the key is pressed again or the weight readout on the
display is touched again. While the weight is locked, the weight status will
change to LOCKED in order to denote that the weight is being held.
This is the ID key. Press and release this key to open the ID entry screen
where you can use the touch screen to enter in a numeric ID. This ID is NOT
used for tracking patient measurements. The ID that is entered is only
transmitted out of the communication port when the
change or edit the ID, simply press the ID key again to return to the ID entry
screen.
This is the Display Mode key. Press and release this key to cause the display
to cycle between display modes: Weight/Height/BMI or Weight only.
This is the Menu key. Press and release this key to launch the Menu screen.
The first screen that is displayed is the Setup Review screen where you can
see all of the settings at a glance. To continue into setup, touch the Setup key
at the bottom right of the touch screen.
This is the Enter key. Press and release this key to signal completion of the
entry of data and cause the indicator to output the current weight, height,
and BMI for data capture for EMR/EHR purposes. The options include
Cardinal SMA, Welch Allyn, Tanita, or IEEE 11073-10415 formats.
855RMP ONLY
This is the Print key. Press and release this key to cause the indicator to output
the current patient information (ID and Gross, Tare and Net Weight) to the
printer for record keeping.
6
key is pressed. To
3300-0298-0M Rev B 05/18