Vermont Castings LHECDV30 Homeowner's Installation And Operating Manual page 10

LHEDV Series Direct Vent Insert
Flue gas exits
through the vent
termination rain
cap
Outside combus-
tion air enters
through the lower
level of the vent
termination
Secure with
clamp and
three screws
Air Intake
Air intake collar with
label secured with
clamp and three
screws
Fig. 12 Liner installatin with A or B vent.
FP1280
RHEDV
vent termination
Flue Collar
1/03
Plate
FP1281
Fig. 13 Remove flue collar plate assembly.
10
1) Attach flexible pipe
to rain cap
2) Secure with clamp
3) Attach raincap to
vent termination using
three screws
Pull flexible pipe
through vent
termination
A or B Vent with
7" Inside Minimum and
14" Outside Maximum
NOTE:
Minimum Vent Height
- 12 feet
Maximum Vent Height
- 35 feet
Exhaust
Exhaust collar se-
cured with clamp and
three screws
FP1280b
Fastener
Plate
Cabinet
10/24" x 1¹⁄₂"
Machine Screw
FP1281
Flue collar plate
Unit
Fig. 14 Apply high temperature sealant to end of collar.
Front
Frame
Fig. 15 Fasten with two clamps, adjust fastener plate all the
way back.
Flue
Collar
Plate
FP1284
Fig. 16 The flue collar plate must be completely in contact
with back edge of cabinet top.
Plate Flue
Collar
Top
FP1285
Fig. 17 Use machine screw to bolt fastener plate in place.
Damper
Damper
FP1282
flue collar seal
1/03
Unit
FP1283
unit in place
1/03
Make sure the flue collar
plate is in contact with the
back edge of the cabinet
top
FP1284
Fastener Plate
RHEDV flue collar
plate in place
1/03
Machine Screw After
Fastened
FP1285
flue collar plate
in place
3" Flex Vent
Two Pieces
Clamps &
Screw
Fastener
Plate
Gasket
FP1282
3" Chimney Liner
Two Pieces
Clamps &
screw
Flue Collar
Plate
FP1283
Fastener Plate
Cabinet
Top
Cabinet
Top
10004894