Fuel Conversion - Vermont Castings Chateau DVT44 Installation Instructions And Homeowner's Manual

WARNING! This conversion kit shall be installed
by a qualified service agency in accordance with
the manufacturer's instructions and all appli-
cable codes and requirements of the authority
having jurisdiction. If the information in these
instructions is not followed exactly, a fire, explo-
sion or production of carbon monoxide may
result causing property damage, personal injury
or loss of life. The qualified service agency is
responsible for the proper installation of this
kit. The installation is not proper and complete
until the operation of the converted appliance
is checked as specified in the manufacturer's
instructions supplied with the kit.
CAUTION: The gas supply shall be shut off prior
to disconnecting the electrical power, before pro-
ceeding with the conversion.
Avertissement: Cette trousse de conversion
Ne doit être installée que par le représentant d'un
organisme qualifié et conformément aux instruc-
tions du fabricant et aux codes et exigences
pertinentes de l'autorité compétente. Quiconque
ne respecte pas à la lettre les instrucitons du
présent guide risque de déclencher un incendie,
une explosion ou le dégagement de monoxyde
de carbone entraînant des dommages matéri-
els, des lésions corporelles ou la perte de vies
humaines. L'organisme qualifié qui effectur les
travaux est responsible de l'installation de cette
trousse. L'installation n'est pas terminée tant que
le fonctionnement de l'appareil converti n'a pas
été vérifié selon la notice du fabricant qui accom-
pagne la trousse.
ATTENTION: Avant d'effectuer la conversin, coupez
d'abord l'limentation en gaz, ensuite, coupez
l'alimentation électrique.
Conversion Precautions
Allow unit to cool if it has been operating.
Before proceeding with conversion, turn gas supply
OFF. Turn OFF any electricity that may be going to ap-
pliance.
Conversion Procedure
1. Remove glass frame. Refer to Glass Frame Assem-
bly section on Page 21.
2. Remove lava rock, volcanic rock, embers and logs.
CAUTION: Logs may be hot.
3. With a Phillips or Robertson screwdriver, remove
the two (2) screws holding the fettle to the burner
20011956
Fuel Conversion Instructions
4. Using a 3/8" hex, remove two (2) hex nuts holding
Fig. 54 Use 3/8" socket to remove hex nuts holding left
burner leg.
5. Slide the burner housing assembly to the left and
6. Replace the three (3) injectors. Refer to Table 1.
7. Replace pilot orifice.
8. Remove pilot hood by lifting up. (Fig. 55) NOTE: It
9. Remove pilot orifice with 5/32" Allen wrench. (Fig.
Pilot
Bracket
Fig. 55 Remove pilot hood.
assemblies. Using 3/8" hex, remove the two (2) hex
nuts (located between the burner tube assembly and
the burner housing) holding the burner tube to the
base pan assembly.
the left burner leg and remove the two (2) hex nut
that tie the burner housing to the right and left burner
leg. Remove burner leg. (Fig. 54)
Remove
Hex Nuts
FP1559a
away. Adjust air shutter setting. Pull burner tube
remove nuts
assembly forward and out. Adjust air shutter setting.
3/05
Refer to Table 2 on Page 35.
is not necessary to remove the pilot tube for conver-
sion.
56)
CO133
pilot hood
3/07
Chateau™
FP1559a
Pilot Hood
CO133
33