Assembly Procedures; Unpack The Firebox; Install Optional Fan Kit - Vermont Castings 4030 - 4049 Installation And Operating Manual

Unpack the Stove
The UVS27 is shipped fully assembled on its back.
Unpack the stove and carefully set it upright.
CAUTION
Porcelain enamelled surfaces are fragile. Handle
porcelain enamelled castings tenderly. Familiarize
yourself with the assembly steps before you begin
and proceed with deliberation and care. If possible,
have assistance available.
Place enamelled castings on a soft, cushioned sur-
face until you are ready to assembly.
Avoid contact between the castings and other hard
surfaces or objects.

Install Optional Fan Kit

1. Remove shroud assembly by loosening two (2) hex
head bolts on lower inside of shroud. Lift shroud as-
sembly up and away from stove.
2. Attach the fan to the rear shroud by engaging the
upper flange of the fan skirt under the lower edge of
the shroud and secure the skirt with the four screws
and one star washer provided. (Figs. 4, 5)
Fig. 4 Place upper flange behind lower edge of shroud.
ST344a
pinnacle
install fan
2/4/00
Fig. 5 Correct position of fan skirt installation.
3. Feed the snapstat wire lead up between the inner and
outer rear shroud panels and secure the snapstat to
the upper right side of the inner shroud. (Fig. 6)
20007068

Assembly Procedures

Upper
Flange
ST344a
ST345a
ST345a
pinnacle
fan in place
12/18/03
4. Secure the snapstat wire harness to the shroud
panel using the wire tie provided.
5. Replace shroud and tighten the two (2) hex head
nuts on lower inside of shroud.
6. Route the rheostat control switch and wire forward
under the stove. Use the wire tie to secure the fan
and rheostat wire harnesses together to the tubing
under the bottom heat shield.
7. Install the rheostat onto the bracket to the left of the
valve. (Fig. 7)
Fig. 6 Attach snapstat to inner shroud.
Rheostat
Fig. 7 Attach rheostat to bracket.
MOTOR
FK104
Install cover plate
ST346a
install FK28
BLK
snapstat
12/18/03
Fig. 8 Fan wiring diagram.
WARNING
Failure to position the parts in accordance with these
diagrams, or failure to use only parts specifically ap-
proved with this heater may result in property dam-
age or personal injury.
UVS27 Vent-Free Gas Heater
Retaining Nut
Control Knob
BLK
SNAPSTAT
WHT
ON/OFF
RHEOSTAT
ST236
FK26 wiring diagram
12/99
ST346a
FK104
ST236
9