Advertisement
Built-In (BI) Series
Built-In (BI) Series
Framed / Overlay Door Handle / Handle-Side Trim
The door handle on framed units and the handle-side
trim on overlay units is attached to the door with
screws. These screws are covered by a screw cover.
To remove a handle of handle-side trim, open the door
then:
1. At the top of the door, insert a flat blade screwdriver
into the channel of the screw cover and push the
cover back, disengaging it from the handle or trim
(See Figure 6-85).
2. With a T-20, 6-lobe Torx type bit, extract the handle-
side trim mounting screws and pull the trim from the
door (See Figure 6-86).
Stainless Steel Door Handle Assembly
A screw inserted through the stainless steel handle
standoffs into the handle secures the handle to the
standoffs. The standoffs are then slides over threaded
studs that are attached to the door shell. A socket head
set-screw inserted through the side of the standoff
secures the standoff to the stud.
To remove a stainless steel handle assembly (See
Figure 6-87):
1. Use a 3/32" Allen-wrench to loosen the set-screw in
each handle standoff.
2. Pull handle assembly off of the threaded studs.
(SWS #4380000)
(SWS #4380000)
Figure 6-85. Screw Cover Removal
Figure 6-86. Handle / Handle-Side Trim Removal
Handle Mount
Screw
Handle
Figure 6-87. Cut-away View of SS Handle Assembly
6-35
Component Removal
Handle Standoff
Threaded Stud
Set-Screw
7040317 - Revision A - September, 2015
Advertisement
