Advertisement
Component Removal
Water Filter Manifold/Valve
The water filter and manifold are located at the right-
hand top side of the unit behind grille assembly.
NOTE: Before attempting to remove the water filter
manifold, switch the water supply to the unit off.
To remove the water filter manifold, first remove the
water filter, then (See Figure 6-82):
1. Extract mounting screws from mounting bracket.
2. Disconnect wire leads from manifold.
3. Disconnect water tubes from manifold.
4. Extract mounting screws from manifold mounting
bracket and pull manifold forward.
Door Switch
The door switch is located at the top rear of the top
cabinet frame, with the switch's actuator protruding
through a hole in the front of the frame. A series of tabs
and pegs hold the door switch in place.
To remove a door switch, first open the grill, then (See
Figure 6-83):
1. Disconnect the switch electrical leads using a nee-
dle-nose pliers to pull the electrical lead housings
away from the switch.
2. Use a small flat-blade screwdriver to pry the front
retaining tab at each side of the switch back while
lifting that side of the switch up. Repeat this step
on each side of the switch.
3. Pull switch back and lift off of the top cabinet frame
Top Cabinet Trim
The top cabinet trim sits below the grille assembly.
Screws pass through open ended slots in the trim to
secure it to the top cabinet frame.
To remove the top cabinet trim first open the grill then,
(See Figure 6-84):
1. Use a T-15, 6-lobe Torx type bit, to loosen, but not
remove, the trim mounting screws.
2. Pull the trim forward. off of the unit.
7040317 - Revision A - September, 2015
Built-In (BI) Series
Built-In (BI) Series
Screws
Water
Connection
Figure 6-82. Filter Manifold (Rear View)
Trim Mounting Screws
Figure 6-84. Top Cabinet Trim Removal
6-34
(SWS #4380000)
(SWS #4380000)
Manifold/Valve
Figure 6-83. Door Switch Removal
Electrical
Connection
Water
Connection
Retaining Tab
Top Cabinet Trim
Advertisement
