Advertisement
Component Removal
Icemaker Assembly
The icemaker assembly is attached to the left side of
the middle duct assembly with screws.
To remove ice maker, first remove the fixed glass shelf
assembly and the upper freezer basket assembly, then
(See Figure 6-99):
1. Use a small flat-blade screwdriver to pry latches of
male electrical connector from tabs of female con-
nector, then disconnect icemaker electrical leads.
2. Extract icemaker mounting screws (two at top, one
at bottom), then pull icemaker assembly from com-
partment.
Lower Light Diffuser
The lower light diffuser behind the upper freezer basket
assembly is a flexible plastic material and is held in
place with flanges at the top and bottom of the diffuser
fitting over metal flanges that Are attached to the lower
duct assembly.
To remove the light diffuser, first remove the fixed glass
shelf and upper freezer basket, then (See Figure 6-
100):
1. At each end of diffuser, pull it down to disengage
diffuser bottom flange from behind lower metal
flange.
2. At each end of diffuser, pull it forward to disengage
diffuser top flange from behind upper metal flange
and remove diffuser from the compartment.
Upper Light Diffuser Assembly
The upper light diffuser assembly, located at the top of
the freezer compartment, is held in place by inverted T-
shaped slots at its sides fitting over pegs on the light
diffuser brackets.
To remove the upper light diffuser assembly (See
Figure 6-101):
1. Push diffuser toward rear of unit until center of
inverted T-shaped slots line up with diffuser bracket
pegs.
2. Lower diffuser down and pull it from the compart-
ment.
NOTE: When reinstalling the light diffuser, be sure to
pull it forward fully so that the tabs inside the inverted T-
shaped slots engage the pegs in the diffuser brackets.
Failure to do so will allow the diffuser to fall out easily.
7040317 - Revision A - September, 2015
Built-In (BI) Series
Built-In (BI) Series
Icemaker
Assembly
Screws
Figure 6-99. Icemaker Assembly Removal
Figure 6-100. Lower Light Diffuser Removal
Figure 6-101. Upper Light Diffuser Removal
6-40
(SWS #4380000)
(SWS #4380000)
Electrical
Connection
Diffuser Brackets
Advertisement
