Table of Contents
Advertisement
When you turn on your television set for the
first time, be sure to place it on a solid stable
surface. To avoid danger, do not expose the
TV to water, or a heat source (e.g. lamp,
candle, radiator). Do not obstruct the
ventilation grid at the rear and be sure to
leave sufficient gaps around the unit as
shown.
TURNING ON THE UNIT FOR THE FIRST TIME
The first time you turn on the unit, the unit will enter Setup mode. You can easily follow the prompt
message on the screen to complete basic TV settings.
Make sure the RF aerial has been
connected
properly
TV ANTENNA input jack on the rear
of the system.
Proceed with auto scan ?
No
:SELECT
1. Press the
/
button to select Yes. Press the
ENTER button to proceed with the initial setup.
PICTURE
AUDIO
TIME
Cable System
Start to Scan
UP/DOWN
ADJUST "MENU":EXIT
3. Use the
/
button to select Auto Scan, then press the
/
button to select Start to Scan, and press the
on Step 2, you need to select Cable System before Start to Scan). The system will automatically start
to scan and preset all available TV channels.
4. After scanning has finished, the system will return to the first TV channel scanned.
PLV16198S2_01-11.pmd
QUICK INSTALLATION
to
the
Yes
"ENTER":COMFIRM
SET UP PARENTAL
TV
TV
AUTO
E - 4
4
PICTURE
AUDIO
TIME
SET UP PARENTAL
Antenna
Auto Scan
Auto Scan Add CH
Channel Skip
Channel No.
Channel Label
DTV Signal
UP/DOWN
ADJUST "MENU":EXIT
2. Use the
/
button to select Antenna, then
press the
/
button to select Air or CATV.
PICTURE
AUDIO
TIME
SET UP PARENTAL
RF CH
:
Found
:
PRESS <MENU> TO EXIT AUTO SCAN
button to enter auto scan menu. Use the
button to begin scanning (If you selected CATV
9/7/2007, 12:30 PM
TV
TV
CATV
TV
TV
16
0
Hide quick links:
Advertisement
Table of Contents
