Quick Installation - Venturer PLV16198 Instruction Manual

19” digital lcd tv

Hide thumbs Also See for PLV16198:

Owner's manual (22 pages)

Table Of Contents

Table of Contents

ATTACHING THE BASE STAND

• Before attaching (or detaching) the stand, unplug the AC cord from the AC input terminal.

WARNING: The LCD display is very fragile and

must be protected at all times when attaching

the base stand. Be sure that nothing hard or

sharp, or anything that could scratch or damage

the LCD display, comes in contact with it. Do

NOT place pressure on the front of the unit at

any time because the screen could crack.

CAUTIONS:

• Attach the base stand in the correct direction.

• Incorrect installation of the stand may result

in the unit falling over.

• Be sure to follow the instructions.

1. Confirm 4 screws (silver screws x2 & black

screws x2) are supplied with the unit.

2. Lay the unit down on a flat surface, so the

backside is facing up, making sure to place

a soft cushioned material (such as a pillow

or thick piece of foam) beneath the screen.

3. Attach the BASE STAND to the opening on

the rear of the unit.

4. Insert and tighten the four screws (supplied)

into the holes as shown below.

Note: To detach the base stand, perform the

steps in reverse order.

MOUNTING ON THE WALL

This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 3 15/16" x 3 15/

16" (100mm x 100mm) mounting kit designed for flat-panel TVs (sold separately). Mount this unit

according to the directions included with the mounting kit.

PLV16198S2_01-11.pmd