Quick Installation; Turning On The Unit For The First Time - Venturer PLV76198E Owner's Manual

19” lcd tv

Table of Contents

When you turn on your television set for the first time, be sure to place it on a solid stable surface. To avoid danger, do

not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct the ventilation grid at the rear

and be sure to leave sufficient gaps around the unit as shown.

1. Connect an antenna or Cable TV COAX cable to the TV's

antenna input jack.

2. Connect the power cord.

3. Press the

/ ON button to turn on the unit.

4. Use the

button to highlight OSD Language, then press

the ENTER or

button to select the menu language from

English / Español / Français.

5. Press the

button to highlight Antenna, then use the

ENTER or

button to select "Air", "Cable STD", "Cable HRC",

"Cable IRC" or "Cable Auto".

6. Use the

button to highlight Auto Scan, then press the

ENTER or

button to confirm.

7. The unit will immediately search all channels for those with

adequate signal strength and store those channels with signals

in memory. The unit will take a few minutes to finish auto scan

and after this is completed, the unit will switch to the first

channel found.

If you subscribe to Cable TV Service, we recommend you pick

"Cable Auto", however you might find you get improved results

using "Cable STD", "Cable IRC", or "Cable HRC" - these are

different standards used by various Cable Systems.

TURNING ON ThE UNIT FOR ThE FIRST TIME

The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt message on the

screen to complete basic TV settings.

Make sure the TV antenna or CATV cable has been connected properly to the TV antenna input jack on the rear of

the system.

PLV76198S23E10 IB ENG.indd 5