Installation Instructions - Varimixer W40(A) Spare Part And Operation Manual

Read this page entirely BEFORE beginning installation.
The mixer must be mounted with the rubber feet, which neutralize both shaking and rusting. Spacers
can be inserted under the mixer's feet if the floor is uneven. The mixer can be bolted to the floor if
desired.
Before the mixer is connected to power, it should be checked that the voltage and frequency on the
rating plate is correct in relation to the place of installation. A unit labeled 220V 3 Phase will operate
from 208V to 240V 3 phase safely. The rating plate is located on the rear right side of the mixer. The
electrical connection box is located at the top rear of the mixer.
Electrical and grounding connections must comply with applicable portions of the National Electrical
Code and/or other local electrical
1. Lower the bowl lift lever.
4. Close bowl screen if equipped.
VARIMIXER INSTALLATION INSTRUCTIONS
codes................................................................ire
Wire Color Codes
White-Phase 1
No Neutral is used
2. Remove the bowl and all tools.
5. Turn timer to 10 minutes and
WARNING
Red -Phase 2
Black-Phase 3
Green-Ground
push "start" .
2
3. Raise the bowl lift.
6. Insure cover is rotating in
the correct direction.