ARRI L Series User Manual page 8

Specific Safety Information
Intensive use can cause the surface and the heat sink
to become warm. Let the product cool down complete
before you handle it.
Never cover air vents and the heat sink during opera-
tion. Keep a minimum clearance around the product
of 0.5 m / 1.65 ft.
WARNING! Intense light. Never look direct into the
light source.
Never point a light beam from another luminaire into
the light source. Do not place the product on heat
sources. Intense heat cause automatic power off
during operation.
WARNING! The stirrup must be mounted hanging or
standing vertically. Lateral load can cause deforma-
tion or breaking of the spigot and the stirrup.
Devices and accessories must be secured against fall
when mounted above floor level. Always observe
common and local safety regulations.
Never use the cables for transportation. Never hang
the product on its cables.
8
CAUTION! High voltage! Always disconnect the prod-
uct complete from mains voltage before you connect
or disconnect a cable!
Always check that the local AC power matches the
voltage and frequency range printed on the type label
of the product before use. Never use the product
when the AC power does not match.
Never connect the product to a dimmer-system or a
dimmer-channel in non-dim mode. To do so will dam-
age the electronics. Damages caused by connecting
the product to a not suitable power source are not
covered by the warranty.
Always keep cables away from the product during
operation. Do not tilt the power cable directly after the
cable glance. Water could immerse and cause short
circuits and damage the connector.
Disconnect all data cables prior to transport.
Not to observe these safety information or to ignore
common sense may cause serious injury or even
death. Damage to the product or other devices is pos-
sible.
Please observe the information given in the „Safety leaflet
ARRI lampheads" (L5.40731.E). The leaflet is available for
download on our web site www.arri.com.