ARRI L Series User Manual page 24

Recent temperature
To display the recent temperature of the light engine:
• Press the + / [up] or - / [down] button, until STATUS is dis-
played left in the display.
• Confirm with the ENTER button. Press the + / [up] or - / [down]
button until the temperature (e.g. 42,1°) is displayed.
• Press the FUNCT button to leave the menu.
Error status
To display the error status:
• Press the + / [up] or - / [down] button, until STATUS is dis-
played left in the display.
• Confirm with the ENTER button.
• If there is no error, OK will be displayed. Otherwise the error
code is displayed (see "Error Messages" on page 33).
• Press the FUNCT button to leave the menu.
Short cuts
The demo mode, setting the DMX address and DMX mode can
be called up via short cuts in the fixture menu:
• Press and hold the ENTER button, until JUMP is displayed in
the display (from every menu).
• Press and hold the FUNCT button to activate the demo mode.
Press the ENTER button again to deactivate the demo mode.
• Press the + / [up] button to set the DMX address.
24
• Press the - / [down] button to set the DMX mode.
The JUMP menu closes 3 sec. after the last key press or after
pressing the ENTER button.
Demo mode
In demo mode the L7 calls up an endless loop with all features
the L7 supports.
• L7-TT and L7-DT: Change of the color temperature from
warm to cold and vice versa. Set the intensity with the dimmer
knob. Set the speed with the CCT knob from 0-100% (60 s -
1 s).
• L7-C: Call up the color spectrum or change the color temper-
ature from warm to cold and vice versa. Set the intensity with
the dimmer knob. Set the speed with the CCT knob from 0-
100% (60 s - 1 s). The GN knob sets the saturation and
changes between color and color temperature sequence.
With GN at „0" the color temperature loop is active. Turn the
GN knob clockwise to increase the saturation to 100%.
• Press the JUMP and FUNCT button or the FUNCT button
alone to deactivate the demo mode.
As an alternative activate and deactivate the demo mode in the
menu Setup -> DEMO.
Shift key
This short cut is only available in the main menu. Press the
ENTER button, until a small arrow starts blinking in the display.
Memory 1 or memory 2 calls up one of two factory settings.