Error Messages - ARRI L Series User Manual

Error Messages

Code Error
Controller over temperature.
E.003
STATUS lit up red.
E.004 Light engine over temperature
E.005 Power supply over temperature
Calibration data of light engine
E.006
faulty or EEPROM error.
E.007 Invalid PWM value calculation
E.008 Invalid values during calculation
E.009 Invalid values during calculation
Fan error. The fan speed devi-
E.010
ates or the fan doesn't run at all.
From SW version 1.72.0
Fixture menu module not be
E.011
detected.
Temperature sensor(s) are
E.012 defective or deviation within
NTC values too high.
Remedy
Let the product cool down. The STATUS indicator changes to green when the product has
cooled down. Turn the dimmer knob to „0" or send an intensity value „0" via DMX to acti-
vate the light engine again.
See E.003
See E.003
WARNING: Loss of calibration data. This error can only be fixed by re-calibrating the light
engine. Please contact the ARRI service.
Notice: The product can be used on. This message is more a notification than an error.
See E.007
See E.007
Set the fan to LOW or HI and see if it starts rotating, in order to determine if there is an
electrical malfunction.
All mechanical tests or repairs may only be carried out by a trained service technician.
If the fixture menu is working, error E.011 can be ignored. However, if the fixture menu
remains dark (no LED lights up) we recommend to contact the ARRI service. They can
then carry out detailed analyses.
One or more temperature sensors are defective or the deviation within the individual NTCs
or BNTCs exceeds the variation tolerance of 12° C / 54° F. Check the error log (LSeries
Manager) to see which temperature sensors are affected. Contact the ARRI service.
33