Installation And Setup; Connections - Panasonic KX-TGP700 Operating Instructions Manual

9.1 Installation and Setup

9.1 Installation and Setup
Note
• Panasonic assumes no responsibility for injuries or property damage resulting from
failures arising out of improper installation or operation inconsistent with this
documentation.
WARNING
• To reduce the risk of fire or electric shock, do not overload AC outlets and extension
cords.
• Completely insert the AC adaptor/power plug into the AC outlet. Failure to do so may
cause electric shock and/or excessive heat resulting in a fire.
• Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it from the
power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation
defect from moisture, etc. resulting in a fire.

9.2 Connections

KX-TGP700 (Base unit)
Connect the AC adaptor and the Ethernet cable to the base unit.
• Check the label color of the AC adaptor cord and the label color nearby DC jack of the
KX-TGP700. The color of the label must match the AC adaptor cord for the
KX-TGP700.
• If PoE is available, an AC adaptor is not needed.
• If you are using a PoE hub, the number of devices that you can connect simultaneously
is limited by the amount of power supplied by the hub.
112
PNLV236xx
Hub