Router-Id Ipv4 Unicast - Cisco NCS 1004 Command Reference Manual

router-id ipv4 unicast

router-id ipv4 unicast
To configure the LMP unicast or neighbor router ID for GMPLS, use the router-id command in the LMP
GMPLS UNI configuration or LMP GMPLS UNI neighbor configuration mode.
router-id ipv4 unicast address
Syntax Description
address
None
Command Default
LMP GMPLS UNI configuration
Command Modes
LMP GMPLS UNI neighbor configuration
Command History
Release
Release
7.0.1
Example
The following example shows how to specify a router ID (address 10.10.4.4) for GMPLS UNI.
RP/0/RP0/CPU0:ios(config)#lmp
RP/0/RP0/CPU0:ios(config-lmp)#gmpls optical-uni
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni)#router-id ipv4 unicast 10.10.4.4
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni)
The following example shows how to specify the neighbor router ID 10.10.5.5 for GMPLS UNI.
RP/0/RP0/CPU0:ios(config)#lmp
RP/0/RP0/CPU0:ios(config-lmp)#gmpls optical-uni
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni)#neighbor UN01
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni-nbr-UN01)#router-id ipv4 unicast 10.10.5.5
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni-nbr-UN01)#
Command Reference for Cisco NCS 1004
64
Specifies the GMPLS UNI optical router-id (IPv4 address).
Modification
This command is
introduced.
Commands