Recalling Pre-Programmed Settings - Universal Remote Control Customizer URC-300 Owner's Manual

Recalling Pre-Programmed Settings

If you didn't write down the code numbers you setup
your Customizer with, you can recall them via this
simple process:
Enter SETUP mode by pressing and holding both
1
MAIN and ENT for three seconds.
Note: You have 30 seconds for each step, otherwise the
Customizer will time out automatically.
Press the RECAL button. The display changes to
2
the recall screens. Each of the four screens dis-
plays the Device Name and the Code Number.
Note: Use the page buttons to display any of the four
pages of devices and their code numbers.
Write down the code numbers as they appear. Page
3
32 of this manual gives a convenient list for you to
note your settings.
Return to normal operation by pressing the MAIN
4
button twice.
U R C - 3 0 0
29