Installing The Hitch Assembly - Toro GreensPro 1240 Operator's Manual

3. Install the transport wheels onto the wheel hubs with
the lug nuts. Hand-tighten the lug nuts.
Note: The lug nuts will be torqued at the completion
of step 2.
4. Adjust the tire pressure to 69 kPa (10 psi).
2

Installing the Hitch Assembly

Parts needed for this procedure:
1 Hitch assembly
1 Bolt (M10 x 100 mm)
2
Washer (M10)
1 Nut (M10)
1 Bolt (M12 x 100 mm)
2 Washer (M12)
1
Nut (M12)
2 Spacer washer (when applicable)
Procedure
1. Secure the hitch to the hitch pivot bracket with the
appropriate hardware; refer to
•
In the front holes, use a bolt (M10 x 100 mm), 2
washers (M10), and a nut (M10).
•
In the rear holes, use a bolt (M12 x 100 mm), 2
washers (M12), and a nut (M12).
•
If your machine has a 3rd washer included with
each bolt, use those washers as spacers between
the hitch and the inside of the hitch pivot bracket
(Figure 5).
Note: Use the holes in the hitch pivot bracket to
match the hitch height of the tow-vehicle hitch.
Figure 4.
12
Figure 4
1. Hitch
2. Hitch pivot bracket
3. Washer (M10), 2
4. Bolt (M10)
Figure 5
1. Spacer washers
2. Tighten the front bolts to 73 N-m (54 ft-lb) and the
back bolts to 171 N-m (126 ft-lb).
5. Washer (M12), 2
6. Bolt (M12)
7. Nut (M12)
8. Nut (M10)