Toro 125-5180 Installation Instructions

Rear Roller Extension Kit
Greensmaster
Model No. 125-5180
Installation
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
1. Raise the rear of the cutting unit and place a block
under the bedknife.
2. Remove and discard the 2 nuts securing each roller.
Retain the shim, but discard the bolts, roller spacer, and
roller retainer (Figure 1).
Figure 1
1. Mounting nuts
2. Side plate mounting flange 5. Roller retainer
3. Shim
3. Install the loose parts and previously removed shim
as shown in Figure 2 or Figure 3, depending on the
desired height-of-cut.
4. Adjust to the desired height-of-cut, and tighten the
height of cut arm mounting fasteners.
© 2013—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
All manuals and user guides at all-guidesbox.com
® DPA Reel Mowers
4. Roller spacer
Register at www.Toro.com.
Installation Instructions
Figure 2
Height-of-cut between 3–25 mm (1/8–1 inch)
1. Flange-head nut
2. Shim
3. Set screw
4. Roller spacer
Original Instructions (EN) All Rights Reserved *3376-266* A
Printed in the USA
Form No. 3376-266 Rev A
5. Roller retainer
6. Long bolt
7. Short bolt