Cleaning Under Display Pan; Cleaning Evaporation Pan - Hussmann microSC GSVM A Series Installation & Operation Manual

P/N 3109358_B

CLEANING UNDER DISPLAY PAN

Remove all product from the merchandiser and
place in cooler . Always disconnect electrical
power before cleaning .
1 . Remove the display pan .
2 . Use non-abrasive cleaning materials and a
mild detergent to clean display pan .
3 . Wipe down the insides of the merchandiser
with a mild detergent, and replace display
pan . Allow merchandiser to pull down in
temperature before loading product .
Fan
Merchandiser with Display Pan removed
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.

CLEANING EVAPORATION PAN

GSVM-4060A GSVM-4072A/5272A
The condensate water outlet for self
contained models empties into a limited
capacity evaporation pan .
Debris or dirt accumulation inside the condensate
evaporation pan or on the heater coil will
reduce the pan's evaporation capacity and
cause premature heater failure . The evaporation
pan waste water will overflow and spill onto the
floor if the heater is not properly operating .
Remove accumulated debris from the evaporation
pan . Wipe down heater coil with a cloth and
warm water . Be sure to remove any dirt, debris
or liquids from the heater coil .
Water introduced during cleaning will cause
the evaporation pan to overflow .
Evaporation Pan is Hot!
and poses risk of bodily injury
Wear gloves and protective eye wear when
servicing. Turn off evaporation pan heater,
and allow pan to cool.
SHUT FANS OFF DURING
CLEANING PROCESS.
GSVM-A Open Vertical Merchandisers
4-3
(STANDARD)
–
Always