Table of Contents
Advertisement
Atlas DVR-PVR M1055
PROGRAMMING CHANNEL CONTROL LOCK
By default, the remote control's channel-control capabilities
are locked to the cable converter. The affected keys* are
0 ~ 9, CH+, CH-, ENTER, and LAST. This will guarantee that
you do not inadvertently change a channel on your TV or
VCR. However, you can de-activate this feature to allow full
access to these keys in the TV and VCR modes.
*NOTE: This feature does not affect the AUD mode.
To De-Activate Channel Control Lock:
1.
On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks twice, then release SETUP.
2.
Enter 9 -7- 3. The CBL key will blink twice.
3.
Press CH- once. The CBL key will blink
four times.
4.
Now, the remote control will provide TV and
VCR channel-control capabilities while in the
TV or VCR mode.
To Re-Activate Channel Control Lock:
1.
On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks twice, then release SETUP.
2.
Enter 9 -7- 3. The CBL key will blink twice.
3.
Press CH+ once. The CBL key will blink twice.
4.
Now, regardless of what mode you select
(except AUD), only the channel control
capability of your cable converter will be
accessible.
8/12/04
4:51 PM
Page 15
15
Advertisement
Table of Contents
