Programming Tv Control; Setup Codes For Tvs - Universal Electronics MILLENNIUMTM 3 User Manual

Millennium 3 Mnl M3090

PROGRAMMING TV CONTROL

NOTE: If you own a TV/VCR combination, skip this section and
perform "Programming TV/VCR Combo Control" on page 16.
Locate the brand name of your TV in the Setup Codes For
TVs section below, and write it in the following space.
TV Brand: __________________________________
The brands are listed in alphabetical order with the most
popular codes listed first.You will use one of these codes
to program the Millennium 3 to operate your TV:
1. Turn on the TV.
2. On the Millennium 3, press TV once. Press and
hold SETUP until the LED blinks twice, then
release SETUP.
3. Enter the first four-digit code for your TV. If
you perform this procedure correctly, the LED
will blink twice.
NOTE: If the LED did not blink twice after entering
the code's last digit, then repeat steps 2 through 3 and
try entering the same code again.
4. Aim the Millennium 3 at your TV and press TV
once. The TV should turn off. If it does not
respond, repeat steps 2-3, trying each code for
your brand until you find one that works. If it
still does not work, try searching for the code
(see Searching For Your Code on page 22).
5. Write your TV code in the boxes below for
future reference.
NOTE: Remember, to use the Millennium 3 to operate your TV,
press TV first.

Setup Codes for TVs:

A-Mark 0003
AOC 0030, 0019, 0003, 0052, 0185
Abex 0032
Admiral 0093
Adventura 0046
Aiko 0092
Akai 0030
Alaron 0179
Ambassador 0177
8
8/16/99 9:26 AM Page 8