Advertisement
JAY ®
A. INSTALLING SYNCRA BACK TO SEDEO
PRO SEATING SYSTEM
Please read the following instructions before
beginning the installation. Mounting and adjusting
the Syncra Back should be done without the user
in the power chair. Remove the foam and cover
from the back shell until the mounting and
adjustments are complete. Once complete, replace
foam and cover to the shell assembly. After
finishing the Syncra Back installation, the user can
be seated back in the wheelchair.
1.
Tools Required (included with Q700 or Q500
SEDEO PRO power chair):
a. 5mm hex key
2.
Recommended torque specification is
100-110 in-lbs (11.3-12.4 Nm)
B. BACK SHELL INSTALLATION
1.
Locate four threaded holes in the mounting
plate (A) of SEDEO PRO.
2.
Using 5mm hex key and four M6 socket
head cap screws & washers (B) attach shell
bracket (C) to the plate.
3.
Using 5mm hex key and four M8 flanged
button head cap screws (D), attach shell
assembly (E) to the shell bracket (C) in the
top holes.
C. HEIGHT ADJUSTMENT
1.
Using 5mm hex key, loosen four M8 flanged
button head cap screws (D).
2.
Slide shell assembly up or down to desired
height.
3.
Re-tighten the screws.
2" of height adjustment is available in the shell assembly.
If a lower back height is desired, shell assembly (E) can
be placed in bottom holes of the bracket.
D. WIDTH ADJUSTMENT
Shell assembly can grow a total of 2" (1" per each shell
side). Foam and cover can accommodate a total of 1"
width growth. If more than 1" of width growth is
needed, new foam and cover must be ordered in the
next size. Please contact your dealer or Sunrise
Medical at (800) 333-4000.
9
SYNCRA Back
250480 Rev. A
Advertisement
