Advertisement
JAY ®
1.
Using 5mm hex key, loosen four M8 flanged button
head screws (F). Depending on height of the shell
assembly on the SEDEO PRO back frame, three
M8 flanged button head screws may need to be
loosened instead of four.
2.
Slide each shell wing to desired width.
3.
Re-tighten the screws.
E. INSTALLING BACKREST FOAM AND COVER
1.
Unzip bottom zipper of the cover and the side
lateral edges.
2.
Insert backrest foam into the cover with the
widest section of the foam at the bottom.
3.
Zip the bottom zipper of the cover.
4.
Place the top edge of the backrest shell under the
top flap of the back cover and foam assembly.
5.
Snap the fasteners into place.
6.
Firmly adhere the back cover and foam assembly
to the Velcro on the inside of the backrest shell
and slide the shell edges underneath the flaps on
the cover back.
7.
Zip the side lateral edges into place.
F. CHECK OUT
Ensure that all hardware has been properly tightened according
to suggested specifications.
a.
Make sure all screws are securely tightened before
use.
b.
Check that the Syncra Back is securely attached to
the SEDEO PRO frame monthly by re-tightening
all screws.
c.
Double check fit and comfort for the user before
putting the Syncra Back into use.
d.
Failure to follow this check out procedure could
result in injury and/or damage to your Syncra
Back and/or components.
250480 Rev. A
WARNING
10
SYNCRA Back
Advertisement
