Lead-In Tone - Uniden SUNDOWNER UH-099 Owner's Manual

When
finished, pressl MEM
I
to store onto memory. The displayed Lead-in Delay
ENT
stops flashing and three successive beeps will be heard. pressl TSQ I for about 1.5
seconds to exit. The radio returns to normal operation. Or press
I
TSQ
I
momentarily
to go to the next programmable parameter.
Lead-in Tone
The Lead-in Tone, when programmed, "rides" on the Lead-in Delay. Hence, when
transmitting a SELCALL ID, a continuous tone will be heard for the duration of the
Lead-in Delay.
The main purpose of the Lead-in Tone is to increase the probability of contact between
your unit and another radio
when
TSQ Scanning.
Normally during TSQ Scanning, if a carrier is detected and the unit does not notice
SELCALL information on its first "glance" of the particular signal, scanning resumes.
But if a Lead-in Tone is present, the unit continues to wait until the SELCALL ID is
received.
4.1 From the Lead-in Delay Status (3.1), press
I
TSQ
I
and the following mode
appears.
,- ,-
,O'rC
TOO
I ,~
LI , ,
Note: Tone _1 is the factory default setting of the UH-O99 for Lead-in Tone.
4.2 Next press
I
MEM
I
and Lead-in Tone Editing is possible.
ENT
,- ,-
,onc
TOO
I ,~
LI
,
I
L- Flashing
Usethe
0
to change the Lead-in Tone value.
Channel Knob
Page 25