Table of Contents
Advertisement
Call Alarm Continue
Mode
1. The unit will transmit an Acknowledge
Tone to the Caller.
2. Initially emits an alarm of four successive
beeps for 20 seconds and then two
successive beeps every four seconds continuously
unless answered.
3. Never resumes the Quiet Condition.
4. Continues to check if incoming codes have your Receiver SelcalllD
even though
the Quiet Condition is already opened. When detected, it will send an Acknowledge
Tone to the caller and then resets the Call Alarm.
.
: For both of the above mentioned modes, transmission
by using the Press-to- Talk
button
is possible when the "TSQ" icon is flashing.
Default Setting (Factory
Default)
A. RX SELCALL ID:
B. TX SELCALL ID:
C. Tone Period:
D. Lead-in Delay:
E. Lead-in Tone:
F. Alarm:
00000
00000
40msec
500msec
Tone "1"
Auto
IMPORTANT
Be sure
that
the Tone Format (5 Tone or 6 Tone), Tone Period Setting and the
Lead-in Tone for all of the radios in your group are all the same. Otherwise you
will not be able to selectively
callone anothereffectively.
Page 28
Advertisement
Table of Contents
