Receiver Selcall Id - Uniden SUNDOWNER UH-099 Owner's Manual

Receiver SELCALL ID
To program your own receiver SELCALL ID, perform the following procedure.
Press and Hold
I
TSQ
I,
then turn on the Power.
1.1 Initial Display and Status (factory default:
00000)
RX SELCALL Code Programming
,-, It ,-, ,-, ,-,
UUUUf-t
TSQ
I
,~ "
~ ~
1.2 When the
I
MEM
I
key is pressed while in this condition, the last digit will begin
ENT
to flash and RX Tone Editing is possible.
,-, ,-, ,-, ,-, ,-,
f-tf-tf-tf-tU
LFlaShing
Use the <J or [> to select the digit position. The selected digit will flash.
Rotate the
0
to change the active digit value.
Channel Knob
TSQ
I
,~ "
~ ~
When finished, press
I
MEM
I
to store the RX Code into memory.
ENT
The programmed code flashes and three successive beeps are heard.
Press
I
TSQ
I
for about 1.5 seconds to exit. The radio returns to normal operation.
Or press ITSQ
I
momentarily to go to the next programmable parameter.
1.3 Selecting 5 or 6 Tone Format
1.31 From 5 to 6 Tone Format Setting
While the 5th digit is flashing, press
[>.
A space bar [ -] will appear and
flash.
Page 20