Pentair Pool Products PENTEK G2DT-01 Owner And Operational Manual page 8

1 Phase Simplex
Control Panel for Grinder
and Vortex Pumps
Owner and Operational Manual
#1. Check the incoming power on the top of the command center.
#2. View the current status of your system.
#1.
All three floats are not activated. Only the Control
Power and Alarm Power indicator lights should be
illuminated.
#3.
The Stop float and the Start float are
activated so the Stop float and the Start
float indicator lights are illuminated.
293 S. Wright St, Delavan, WI 53115 Phone: 1-866-973-6835 Fax: 800-426-9446
1 Phase Simplex - How to use the System Test switch
Fuses are good.
If one or both of the indicators
are not illuminated the fuse or
fuses need to be replaced. If
the fuse or fuses do not fix the
problem the incoming power
needs to be examined.
Alarm Float
Start Float
Stop Float
Alarm Float
Start Float
Stop Float
If the indicator lights are illuminated the fuses are good.
Alarm Fuse needs
to be replaced
The indicator lights illuminate as each float rises with the liquid
level in the tank.
Alarm Float
Start Float
Stop Float
If the Stop float is activated the Stop light
will illuminate.
Stop Float
All floats are up so all indicators are illuminated.
Control Fuse
needs to be
Alarm Float
Start Float
#2.
#4.
Page 8 of 10
P10063VSM