Service Scanning - Uniden UBCT9 Owner's Manual

The service scan feature allows you to rotate through the following six service banks.
() Police*
() Rail Roads*
() Aircraft**
(4) Marine Band
(5) UHF CB Band
() AM CB BAND*
* Preset frequencies valid for Australia Only (not valid for NZ)
** Except Aeronautical Radio Navigation (0-.5 MHz)
1. Press SVC to select a Service. 'SERVCE ' appears
on the display with the current service bank
below.
2. Continue pressing SVC until your desired Service is
displayed. eg: Police (POL), RailRoad (RLR),
Aircraft (AIR), Marine (MRN), UHF CB
(UCB), AM CB (ACB).
3. After a three second delay scanning begins. If you
want to start scanning immediately, press
HOLD/RESUME.
Notes: • Press HOLD/RESUME at any time to hold the frequency. Press the
to move up or down the frequency. If you find the frequency you want to store,
while in Hold mode you can store the frequency (see page 21).
• If you want to remain on a frequency until a responding transmission is
received, press DELAY to activate the delay feature (See page 28).
• To skip a frequency, press L/O. You can program up to 100 skip frequencies
from the service frequencies.
UBCT9 OM 25

Service Scanning

5
or key
12/11/07 3:53:42 PM