State Scan Hold; Storing State Scan Frequency; Skip A Frequency - Uniden UBCT9 Owner's Manual

5. To scroll repeatedly, press and hold
STATE.
After 3 seconds, the scanner will begin to scan
through the Police frequencies (Police only).
6. If you want to start scanning immediately, press
HOLD/RESUME.

State Scan Hold

1. When scanning stops on a desired frequency, press
HOLD/RESUME to hold at that frequency as long
as you like.
While "HOLD" appears in this mode, you can
use or to move up or down the frequency steps.
During Hold mode, you can see all frequencies
sequentially. It does not depend on your selected
bank.
Pressing and holding the keys for 1 sec, speeds up
frequency change.
If present frequency is locked out, then "L/O" appears
on LCD.
2. To resume scanning, press HOLD/RESUME.
Storing State Scan Frequencies
You can quickly store any frequency you find during scan.
1. During scan, press HOLD/RESUME to store.
You can press
2. If you have found the frequency you want to store, press E.
- Or-
When the scanner stops on the frequency you want to store, press E.
3. Select the private bank where you want to store the frequency, the smallest empty
channel number and "000.0000" flashes on and off over the frequency you want to
store. Press E (if the frequency you want to store exists already in a bank, you will hear
an error tone and the other channel displays. Press E again to store the frequency in
both channels).

Skip a frequency

To skip a frequency, press L/O. You can program up to 100 skip frequencies.
You can skip the frequencies in the scanning sequence.
If you change the state code, skipped frequencies are cancelled as soon as scanning
starts. If you change the State, skip frequencies are all clear.
UBCT9 OM 16
or
or to move up or down 1 frequency step.
and

12/11/07 3:53:34 PM