On-Air Cloning - Uniden UBC396T Owner's Manual

(Master scanner) Clone Master Press SCAN Key
Scan
(Slave scanner) Clone Slave Press SCAN Key
Scan
When you are ready to clone the scanner, press
on the slave scanner first, then on the master scanner.
The master scanner checks the connection between the
two scanners, then transfers its data to the slave scanner.
When the transfer is complete, Complete appears on
both scanners. If the transfer did not work, Error
appears on the master scanner.

On-Air Cloning

You can clone (copy) data from a PC to a BCD396T
scanner. This is useful if you want to quickly program
20 or more BCD396T scanners at the same time.
Note: On-air cloning is practical if you are
programming more than 10 scanners at the same
time. Otherwise, we recommend you use wired
programming.
Xfer Information
Menu
On-Air Clone
• Start Cloning Start on-air cloning.
• Set Frequency Lets you set the frequency where
your scanner receives the cloning broadcast.
• Set Modulation Lets you set the cloning
broadcast's modulation type.
To clone (copy) data from a PC to the scanner, you
need a transceiver, a PC that has an audio input, and
a cable to connect your PC's sound card to the
transceiver. Follow the directions supplied with the
Uniden Advanced Scanner Director Software (avail-
able online at http://www.uniden.com) to construct a
cable and use on-air cloning.
When you are receiving the cloning broadcast and are
ready to clone the scanner, select Start Cloning
58
Scan
Other Settings