Remote Interface; Connecting The Scanner - Uniden UBC 245XLT Trunk Tracker II Operating Manual

You can communicate and program your UBC245XLT
in numerous ways with peripheral devices using the
RS232C port. This radio offers the following modes:
SMARTSCAN MODE*
Automatically load frequencies, trunking talk
groups and fleetmaps from the Uniden National
Frequency Database server into your scanner
using an external modem or an internal modem
included with a PC.
*The SmartScan feature is not supported at this time. However,
it may become available in the future.
REMOTE (PC Control) MODE
Program and control your scanner remotely from a
PC using third party software (see the flyer
included in the box).
CLONE MODE
Clone all the frequencies and trunking talk groups
and fleet maps programmed into your scanner to
another UBC245XLT.

Connecting the scanner

Scanner to PC
Plug the smaller end of the supplied Remote Interface
cable into the remote port which is on the right side of
the scanner. Plug the other end of the cable (DB-9 serial
connector) into a personal computer's serial port. A few
PC's may require an adapter, most will not. Of course,
make sure your PC is turned on.
To use SmartScan mode with an internal modem, you will
need a small custom software program to allow the serial
port to talk with the internal modem and act as a simple
"pass through" device. To download this free program, go
to Uniden's website, look up under Scanners
"SmartScanner" or the UBC245XLT scanner, for the

Remote Interface

BANK 1 2 3 4 5 6 7 8 9 10
TRUNK
. ATT
BATT
DATA POLICE RR AIR MRN U H F C B
SCAN SEARCH PRI HOLD DLY L /O
62