Remote (Pc Control) Mode - Uniden UBC 245XLT Trunk Tracker II Operating Manual

Remote (PC Control) Mode

You can program and control your scanner remotely from a
PC using third party software. After connecting the scanner
to a PC using the Scanner to PC steps (see page 62), turn
the radio off. Press and hold REMOTE key and turn the
radio on. Then release the key. u bc245 will flash on the
display.
1. The following screen
appears.
2. To control your
scanner using a PC,
press
until this screen is
displayed. Then press
to select the
Remote mode.
3. Use the third party
software as directed.
Start Remote Mode
Turn off the power, then turn it on again.
Press REMOTE key,
until you hear two
short beeps.
REMOTE mode
is selected. To
distinguish from
Normal operation
mode, "KEYLOCK"
icon flashes.
During REMOTE
Control mode, the
scanner will ignore
any key (except
REMOTE key).
For information on purchasing third party software to
program and control your UBC 245XLT, see the flyer
included in the box with this radio.
. Or, press
or
BANK 1
DATA
SCAN
70
2 3 4 5 6 7 8
PRI
9 10