Remote Interface; Smartscan Mode - Uniden BC780XLT Operating Manual

You can communicate and program your BC780XLT in numerous ways with peripheral
devices using the Remote Interface Cable port. This radio offers the following modes:
O

SMARTSCAN MODE

Automatically load frequencies, trunking talkgroups and fleetmaps from the Uniden
National Frequency Database server into your scanner using an external modem or an
internal modem included with a personal computer (PC).
O
REMOTE (PC Control) MODE
Program and control your scanner remotely from a PC using third party software (see the
flyer included in the box).
O
CLONE MODE
Clone all the frequencies, trunking talkgroups, and fleet maps programmed into your
scanner to another BC780XLT scanner.
SmartScan Mode
To connect Scanner to PC:
Plug the scanner end of the RS232C straight interface cable (purchased separately) into the
remote port on the rear of your scanner.
Plug the other end of the cable (DB-9 serial connector) into a personal computers serial
port. A few PCs may require an adapter, most will not. You may need a DB-9 to DB-25 null
modem adapter, or gender changer adapter, available at most computer stores. Of course,
make sure your PC is turned on.
To use SmartScan mode with an internal modem, you will need a small custom software
program to allow the serial port to talk with the internal modem and act as a simple pass
through device. To download this free program, go to Uniden's website, look up under
Scanners - "SmartScanner" or the BC 780XLT scanner, for the SmartScanner software. Run
this program and it should automatically set the port setting for you (although you can
override the settings). Make sure that you have a phone line plugged into the modem jack on
the back of your PC and your scanner is connected to the serial port of the PC using
the RS232C straight cable.
Cables and connectors are available for purchase by calling 1-800-722-6701
or check out www.bc780xlt.com.

Remote Interface

59