Throttle Lever
Move the control forward to increase the engine speed, and
rearward to decrease speed
1. Throttle lever
Depth-Control Lever
The depth-control lever allows you to set the depth of the
flail blades in 10 different cutting positions along with 1
position for transportation.
To adjust the depth, remove the hairpin cotter, pull the
locking pin out, and move the lever forward or rearward to
the desired depth setting
(Figure
Important: Do not pull the lever side-to-side, as this
bends the lever.
(Figure
7).
Figure 7
8).
4
1. Depth-control lever
2. Transport-position hole
Specifications
Note: Specifications and design are subject to change
without notice.
Width
Length (operating)
Length (with handle stored)
Height (operating)
Height (with handle stored)
Weight
Attachments/Accessories
Approved attachments and accessories are available for use
with the machine to enhance and expand its capabilities.
Contact an Authorized Service Dealer or Distributor or go
to www.Toro.com for a list of all approved attachments and
accessories.
8
1
2
3
g025338
Figure 8
3. Hairpin cotter
4. Locking pin
69.9 cm (27.5 inches)
111.8 cm (44 inches)
86.4 cm (34 inches)
94 cm (37 inches)
63.5 cm (25 inches)
61.2 kg (135 lb)