7. Holding the bottom edge of the paper, roll back the roll paper
using the flange on the right to remove the slack. Make sure
that the bottom edge of the paper is straight and in line with
the rows of punch holes.
8. Pull the paper set lever all the way up, then close the roll paper
cover. PRESS PAUSE BUTTON appears on the LCD panel.
Note:
If the Roll Auto Cut light is on and the bottom edge of the roll paper
was not cut properly after the previous print job, press the Paper
Feed button to position the paper in place for cutting (marked
with scissors). Then press the Cut/Eject button to recut the edge.
4-10
Paper Handling