Operating Modes - DeLonghi Fivy Instructions Manual

TURNING ON FOR THE FIRST TIME
After inserting the batteries, set the day of the week and time.
Adjust the day of the week by using the "+"
and "-" keys (1=MON, 2=TUE,...7=SUN), then
confirm by pressing the "Mode" selection key.
The hour starts flashing. In the same way, ad-
just the hour by using the "+" and "-" keys and
confirm with "Mode" selection key.
Minutes are now flashing: repeat the same
procedure.
4.3 ON/STANDBY MODE
In "Standby" mode the current time and the
day of the week appear on the display.
EN
All the operating modes are suspended ("Pilot
Wire" included), but the appliance is powered
and waiting for command reception.
To turn the appliance on or off, press the "Stand-
by" button.
The radiator turns on in the previously select-
ed operating mode and emits a sound.
When first using the remote after replacing
the batteries, the "Comfort" mode is selected.
The entry into "Standby" mode is signalled by
means of a double beep, the exit from "Stand-
by" mode by means of a long beep.

4.4 OPERATING MODES

The appliance provides 5 operating modes
which allow the user to heat the environment
in the most suitable way with respect to his
needs.
Press the "Mode" selection key to select the
desired operating mode. An icon on the LCD
will show the selected operating mode.
Pilot Wire
Night
Chrono
PILOT WIRE
The temperature depends on the "Pilot Wire" com-
mand.
All "Pilot Wire" commands are enabled.
Comfort
Anti-freeze
COMFORT
The "Comfort" temperature corresponds to the tem-
perature desired by the user.
All "Pilot Wire" commands are disabled.
NIGHT
The "Night" mode keeps a comfortable temperature
with a reduced energy consumption.
All "Pilot Wire" commands are disabled.
ANTIFREEZE
In the "Anti-freeze" mode the temperature set point
is fixed at 7°C.
All "Pilot Wire" commands are disabled.
The appliance starts heating automatically when
the room temperature drops below 7°C.
CHRONO
In this mode, you can select one of the three pre-
set chrono-thermostat programs or the custom
program. The latter lets you set a daily and weekly
program with two temperature levels ("Comfort"
and "Night").
All "Pilot Wire" commands are disabled.
4.4.1 PILOT WIRE
To activate the "Pilot Wire" mode:
Press the "Mode" selection key until the icon
appears on the LCD.
On the appliance the upper LED turns red.
Users can only set the "Comfort" temperature
on the remote control.
Select the desired temperature set point by
using the "+" and "-" keys.
The home must be fitted with an automation system sup-
porting this type of technology. In this case, correct trans-
mission of the programming commands can be verified us-
ing the following diagram according to the mode set:
Night
Mode Comfort (Comfort Anti-freeze Standby
-3,5°C)
Signal to be
transmitted
Voltage
between
0 volt 230 volt
Pilot Wire and
neutral wires
5
Comfort Comfort
-1°C -2°C
230 volt 230 volt
115 volt 115 volt For an For an
Negative Positive interval interval
of 3 s of 7 s