Advertisement
Positioning the heater:
•
DO NOT place clothes or other materials on the heater.
•
DO NOT position heater close to chairs or fabrics
•
DO NOT MOVE the heater across the room when lit.
•
DO NOT POSITION the heater alongside a wall or near curtains etc.
•
ALWAYS face the heater towards the centre of the room.
Before connecting a gas container and operating this appliance, please read the heater safety instructions and the operating
instructions given below - spare copies may be obtained from your authorised dealer.
The gas is turned on and off at the cylinder.
The heat input and spark for ignition are controlled by the knob situated at the top right hand side of the heater.
LIGHTING THE HEATER:
1) Turn on the gas cylinder by either:
Turn the regulator gas switch anti- clockwise to the vertical position
2. FROM " " position fully depress the control knob, and turn to
starting position and repeat). Continue to fully depress the knob for a further 10 seconds to allow the thermocouple probe
to heat up, then turn the knob to the required heat setting.
CONTROL OF THE HEAT OUTPUT:
For low output - leave control knob in position
For medium output - slightly depress knob and rotate to position
For full output - slightly depress knob and rotate to position
TURNING-OFF THE HEATER
The heater will only be totally "OFF" when the supply of gas from the cylinder has been turned "OFF" at the valve. After each use the
appliance must be turned "OFF" at the valve.
Turn the regulator gas switch clockwise to the
DO NOT ATTEMPT to relight until FIVE minutes have elapsed.
WARNING FOR SWITCH-ON SYSTEM:
When the heat is alight, NEVER turn the switch on the cylinder to the disconnect position. Wait until heat and pilot go out, then and only
then, should the switch be turned to the disconnect position if the cylinder requires changing.
It is dangerous to switch to the disconnect position when the heater is alight.
OPERATING INSTRUCTIONS
(small flame)
(big flame)
position (Model No. 634R)
5
(Model No.634R)
position (small flame). If pilot does not ignite return to
(medium flame)(only on some models)
Handle verically
OPEN
flame On
Handle horizontally
flame Off
CLOSED
GAS OFF
Advertisement
