Maintenance; Troubleshooting - DeLonghi Fivy Instructions Manual

5. CLEANING
Before cleaning, make sure the appliance is turned
off, cold and disconnected from the household
mains.
To clean, just wipe with a soft damp cloth and
neutral detergent. Never use abrasive or corrosive
cleaning products or solvents.
To maintain efficiency, remove the dust from the
surface and inside of the appliance at least twice a
year using a vacuum cleaner.

7. TROUBLESHOOTING

EN
The appliance does not heat up.
The appliance heats
continuously.
The room stays cold.
Leaks of the liquid in the
appliance.
The appliance does not
respond correctly to orders
received from the Pilot Wire
control unit.
The upper LED becomes
alternating yellow and red.
Check if the radiator is correctly connected to the mains power grid and powered.
Check the position of the mains switch of the installation.
Increase the temperature set point on the appliance regulator.
The safety device has tripped. Eliminate the cause of overheating
(for example, obstructions or covering).
Disconnect the appliance from the household mains for a few minutes to reset the
electronic system.
If it still does not heat up, contact your local dealer or a qualified professional.
Reduce the temperature set point on the appliance regulator.
Make sure the "Overdrive (2h)" function has not been activated accidentally.
If it continues to heat, contact your local dealer or a qualified professional.
Make sure the power of the appliance is adequate for the room to be heated.
If the appliance is being used for the first time, the room takes at least a couple of hours
to heat to the required temperature (setting the radiator to maximum does not raise the
temperature more quickly).
Turn the appliance off and contact your local dealer.
Dry the leaks using gloves to protect from the chemical products. Keep children and pets
away from the liquid.
Disconnect the appliance from the mains power supply (switch off the mains switch by
moving it in the "O" position). Make sure the connection is correct (Fig.8) and the control
unit is functioning correctly.
Contact a qualified professional.
The temperature sensor is malfunctioning. Turn off the appliance and contact your dealer.

6. MAINTENANCE

Should any technical problems arise, contact a
qualified professional (recognised or authorised by
the dealer or manufacturer) or your local dealer.
All operations on the appliance must be carried out
by a qualified professional who before perform-
ing maintenance must make sure the appliance is
turned off, cold and disconnected from the house-
hold mains.
The appliance contains a precise quantity of oil. All
repairs requiring the appliance to be opened must
be performed by a qualified professional.
In the event of oil leaks, contact your local dealer or
a qualified professional.
9