Table of Contents
Advertisement
Installing the Battery
Follow the steps below to install the
rechargeable battery pack.
1. Using the finger indentation, press
in on the battery case cover and
slide it down to remove it.
2. Plug the battery connector into the
battery compartment jack. Be sure
to match the red and black wires to
the label near the jack.
3. Gently pull on the battery wires. If
the battery connector comes
loose, try connecting it again.
4. Replace the battery case cover
and slide it up until it clicks into
place.
Note: Use only the Uniden BT-446 rechargeable battery pack
supplied with your cordless telephone.
Installing the Belt Clip
Line up the tabs with the holes on each
side of the handset. Press the belt clip
down until both tabs click into place.
To remove the belt clip, pull both sides of
the clip to release the tabs from the
holes.
Installing the Optional Headset
Your phone may be used with an optional
headset. To use a headset, insert the
headset plug into the headset jack.
Headsets may be purchased by calling
the Uniden Parts Department. See back
cover page for contact information.
3
Hide quick links:
Advertisement
Table of Contents
